Printing The Buffer Contents; Adjusting The Media Sensor - Intermec 4630 User Manual

4. Press ↑ so that labels move farther forward from the front of the printer.
5. Press Enter at the setting you want.
6. Press Cont to return to the ONLINE READY display.
7. Print several labels. If the labels do not stop at the right point for removal or

Printing the Buffer Contents

You can print the data that is stored in the printer buffer when the printer is
offline.
To print the buffer contents
1. Take the printer offline.
2. Press Cont. The printer prints the contents of the buffer.

Adjusting the Media Sensor

The media sensor performs two functions: it monitors the position of a label
along the media path and it monitors when the label stock must be replaced.
The printer firmware interprets the media sensor input to determine the top of
form position on a label or an out of stock condition with the printer.
The media sensor is adjustable across half of the media path. In general, if the
media sensor adjustment knob is kept in the full counterclockwise position, it
will correctly sense all widths of media. However, if a problem occurs with
sensing the label top of form, try rotating the media sensor adjustment knob
clockwise, one half turn at a time, until the error is eliminated.
Press ↓ so that labels do not move as far forward from the front of the
printer.
Note: The range for the label rest point is from -30 to +30 in 5 mil increments.
cutting, repeat this procedure until you get the results you want.
The printer cannot receive data when it is offline, so the printer can only
print what is in the buffer. When printing stops, the buffer is empty.
Operating and Configuring the Printer
2
2-13