Preparing The Sender Printer; Sending Formats, Fonts, Pages, And Graphics To The Receiver Printer - Intermec 4630 User Manual

4630 and 4830 Bar Code Label Printers User's Manual

Preparing the Sender Printer

1. Connect the main serial ports of the sender and the receiver printers with
2. From the OFFLINE READY display of the sender printer, press Menu and
3. Press Select and the press ↑ or ↓ until the display shows:
4. Press Select.
The sender printer is ready to download data to the receiver printer.
Sending Formats, Fonts, Pages, and Graphics to the
Receiver Printer
You can send pages, formats, fonts, and graphics from the sender printer to the
receiver printer, either all at once or as selected items. Before performing any of
the following procedures, you must have prepared both the sender and
receiver printers.
To download all pages, formats, fonts, and graphics
1. On the sender printer, press ↑ or ↓ until the display shows:
2. Press Select. The display shows:
3. Press Enter to download the data to the receiver printer. During
4. When the downloading process is complete, the display on the sender
5. Disconnect the serial cable from the receiver printer.
5-6
an RS-232 null modem serial cable (Intermec P/N 049353).
then press ↑ or ↓ until you reach the Service menu.
SERVICE MENU
SELECTIVE TRANS
SELECTIVE TRANS
SEND ALL
SEND ALL
EXECUTE TEST
downloading, the display shows:
TRANSFERRING
printer shows:
SEND ALL
EXECUTE TEST