Setting The Maximum Print Speed - Intermec 4630 User Manual

To download specific pages, formats, fonts, or graphics
1. On the sender printer, press ↑ or ↓ until the display shows the item you
2. Press Select and then press ↑ or ↓ until you see the number you want to
3. Press Select. The display prompts you for a number to assign in the receiver
4. Press ↑ or ↓ until you see the number you want and then press Select. In
5. Press Enter to download the item. In this example, you are downloading
6. When downloading is complete, the sender printer display shows:
You can download another item to the receiver printer, or disconnect the
receiver printer and download data to a new receiver printer.

Setting the Maximum Print Speed

The 4630 printer can print up to 8 inches per second (ips) and the 4830 printer
can print up to 5 ips. You need to determine the print speed that produces the
highest quality labels for your application. For example, if you decide that your
printer operates best at 4.0 ips or lower, you may want to set the maximum
print speed to 4.0 ips. Setting the maximum print speed prevents the printer
operator from printing at speeds that exceed 4.0 ips.
Note: The Max Print Speed command only limits the print speed range that can be
selected from the menu panel. You can still set any print speed (up to 8 ips for the 4630
or 5 ips for the 4830) from the host by using PrintSet or the <SI>S configuration
command. For more information on using IPL commands with your printer, refer to
the IPL Programming Reference Manual (P/N 066396).
want to download, for example:
SELECTIVE TRANS
SEND FORMAT
download, for example:
SEND FORMAT
4
printer, for example:
TO FORMAT
1
this example, the display shows:
FORMAT 4 TO 1
EXECUTE TEST
format 4 from the sender printer to format 1 on the receiver printer.
SELECTIVE TRANS
SEND FORMAT
5
Special Procedures
5-7