Intermec 4630 User Manual page 73

Error Message
AC VOLTS LOW
CALLS FAULT
CHECKSUM ERROR
COMMUNICATIONS
ERROR
CUTTER FAULT
CUTTER NOT
CONNECTED
FLOAT FAULT
HEAD LIFT FAULT
MACHINE FAULT
MATH FAULT
MEDIA ALERT
Problem
There is not enough voltage reaching
the printer through the AC power
cord.
The printer microprocessor has
detected an internal fault.
Portions or all of the static memory
were found to be corrupted and were
reset. Some or all of the fonts, UDCs,
formats, configuration settings, etc.,
may have been lost.
Printer is not communicating with the
host computer.
The Cutter is not operating properly.
The cutter is enabled from the control
panel but it is not connected.
The printer microprocessor has
detected an internal fault.
The printhead mechanism has jammed
and the printhead cannot lift between
labels.
The printer microprocessor has
detected an internal fault.
The printer microprocessor has
detected an internal fault.
The Media Alert command is enabled
and the media supply is low.
Troubleshooting
Solution
Test the line voltage. If sufficient
voltage is reaching the printer, then the
problem is internal to the printer and
you should contact your Intermec
service representative. If the printer is
not receiving sufficient voltage, replace
the power cord.
Contact your Intermec representative.
Contact your Intermec representative.
Make sure the host is running and all
the connections are intact. Press Cont
to clear the error.
Check to see the cutter is properly
maintained and connected. Press
Feed/Reload to clear the error.
If you are not using the cutter, disable
the Cutter command through the menu
panel. Otherwise, check the
connections between the cutter and the
printer. Press Cont to clear the error.
Contact your Intermec representative.
Open the printer and press
Feed/Reload. If this does not work,
contact your Intermec representative.
Contact your Intermec representative.
Contact your Intermec representative.
Replenish the media supply (refer to
Chapter 1) or disable the Media Alert
command (refer to Chapter 2). Press
Feed/Reload to clear this warning.
4
4-7