Intermec CK30 User Manual page 74

Chapter 2 — Configuring the CK30
58
To enable WPA-PSK or WPA2-PSK with Funk security
1 Make sure you have configured the communications and
radio parameters on your CK30.
2 Make sure you have selected Funk as your security choice.
3 Press C and then B to open the System Main Menu.
4 Choose Configuration Utility > Communications > 802.11
Radio > Funk Security > Profile.
5 For Association, choose WPA or WPA2 and press Enter.
6 For 802.1x, choose None and press Enter.
7 For Pre-Shared Key, enter the pre-shared key or the
passphrase.
The pre-shared key must be a value of 32 hex pairs preceded
by 0x for a total of 66 characters. The value must match the
key value on the access point. The passphrase must be from 8
to 63 characters. After you enter a passphrase, the CK30
internally converts it to a pre-shared key. .
This value must match the passphrase on the authenticator.
8 Exit the Configuration Utility.
Configuring WPA Security With Microsoft Security
Use these procedures to set WPA-802.1x and WPA-PSK
security on your CK30 with Microsoft security.
To enable WPA security on your CK30 with Microsoft security
1 Make sure you have configured the communications and
radio parameters on your CK30.
2 Press C and then B to open the System Main Menu.
3 Choose Configuration Utility > Communications > 802.11
Radio > Microsoft Security.
4 For Infrastructure Mode, choose Infrastructure and press
Enter.
5 For Network Authentication, choose WPA and press Enter.
Data Encryption automatically defaults to TKIP.
CK30 Handheld Computer User's Manual