Booting The Ck30; Warm Booting The Ck30 - Intermec CK30 User Manual

Chapter 6 — Troubleshooting and Maintaining the CK30
Problems While Scanning Bar Codes (continued)
Problem
The configuration settings in the
Configuration Utility do not match the
settings on your 1551E or 1553.
You receive an error when changing the
scanner model with a serial adapter
attached.

Booting the CK30

Warm Booting the CK30

128
Solution
Try disabling and then enabling the scanner port state to
synchronize the CK30 settings with the scanner.
Try these steps in order:
1
Check to make sure the serial adapter is attached to
the CK30.
2
Disconnect and then reconnect the serial adapter to
the CK30. The green Good Read light flashes to
indicate that the software is auto-detecting the
adapter and loading the software.
3
Warm boot the CK30.
You seldom need to warm or cold boot the CK30. The CK30
uses the configuration currently saved in flash memory during
the boot process.
You need to boot the CK30 when an application is locked up
and will not respond, when you upgrade the firmware, or when
you reflash the computer. The next instructions explain how you
warm and cold boot the CK30.
If your charged CK30 does not resume after pressing I, or if the
computer or an application is locked up, you may need to warm
boot it.
To warm boot the CK30
• Press and hold I for 5 seconds. The CK30 tells you it is
performing a warm boot and the screen comes back up to the
start screen.
CK30 Handheld Computer User's Manual