Display Test; Hardware Configuration Table - Intermec CK30 User Manual

Display Test

Hardware Configuration Table

CK30 Handheld Computer User's Manual
Use the Display Test to make sure that every pixel on the CK30
screen is working correctly. For example, you may want to test
the screen if you do not see complete characters on the screen.
The Display Test turns all pixels on, displays horizontal stripes,
displays vertical stripes, and then turns all pixels off. If you have
a color screen, the display test also changes your screen to blue,
red, and then green.
To open the Display Test diagnostic
• Go to Diagnostics > Hardware Diagnostics > Display Test.
Sample Screen
Use the HW Config Table to view important information about
your CK30 such as the serial number, configuration number,
model, software options, and the scanner type.
You can use this information to tell the Intermec representative
information on the hardware and software that were installed at
the Intermec factory.
To open the HW Config diagnostic
• Go to Diagnostics > Hardware Diagnostics > HW Config
Table.
Chapter 5 — Running Diagnostics
109