Installing an SD Card
CK30 Handheld Computer User's Manual
Chapter 1 — Using the CK30 Handheld Computer
4 Refresh Intermec Settings.
If you attach the undecoded serial adapter, the default scanner
is the 1550C05XX If you attach the decoded serial adapter,
the default scanner is the 1551E.
5 Use Intermec Settings to select your scanner model and
configure the serial port. For help using Intermec Settings, see
"Configuring the CK30 With SmartSystems Console" on
page 38.
Note: When you attach an undecoded serial adapter to the
CK30, the internal scanner does not work.
You can use a Secure Digital (SD) card to increase file storage
and install software. The CK30 currently supports SD cards that
hold up to 1 gigabyte of information. The SD card slot is
located on the top of the CK30 just above the laser scanner
window.
To insert an SD card
1 Press I to turn off the CK30.
2 Remove the two screws on the SD card slot door and remove
the door.
3 Gently insert the SD card into the CK30 with the printed
side facing the keypad and screen side of the CK30.
4 Push the card into the slot until it latches in place and the
steel card retainer covers the end of the SD card.
CK30
SD card
retainer
SD card
29