Intermec CK30 User Manual page 58

Chapter 2 — Configuring the CK30
42
To see an example of the host application transaction, see the
example on page 43.
Configuring the CK30 in a TCP/IP Direct Connect Network
You can use the host computer to configure a wireless or
Ethernet CK30 in your TCP/IP network. To send and receive
configuration data, you need to write a host application that can
communicate with the CK30 directly through an access point or
through the Ethernet network. Use the Terminal Message
Format (TMF) protocol to send and receive transactions
between the host application and the CK30.
To set up the host computer
• Verify that you can communicate with the CK30.
To set up the application
• Prepare and write a host application that can communicate
with the CK30. Send message transactions to and receive
transactions from the CK30 on the network port using this
format:
TMF field
where:
TMF field is a 2-byte field containing one of these values:
CG Configuration Get request sent from the
Cg Configuration Get response sent from the
CS Configuration Set request sent from the
Cs
commands are the reader and configuration commands
that you want to set on the CK30 or the
current value you want to retrieve from the
CK30. To save configuration changes in flash
memory, send the reader command .+1 as the
last command.
commands
host application.
CK30 to the host.
host application.
Configuration Set response sent from the
CK30 to the host.
CK30 Handheld Computer User's Manual