Table of Contents
Advertisement
6-4
Installing the Air Shroud
Air shrouds concentrate airfl ow to maximize fan effi ciency. The SC116 chassis air
shroud does not require screws to set up.
Air Shroud Installation (Figure 6-4)
1. Position the air shroud in alignment with the CPU, memory card and fan
locations.
2. Check the air shroud and serverboard components, removing the break-away
piece from the side of the air shroud if required.
3. Place the air shroud into the chassis.
Checking the Airfl ow
Check the Airfl ow
1. Make sure there are no objects obstructing the airfl ow in and out of the
server. In addition, if you are using a front bezel, make sure the bezel's fi lter
is replaced periodically.
2. Do not operate the server without hard drives or drive carriers in the drive
bays. Use only recommended server parts.
3. Make sure no wires or foreign objects obstruct airfl ow through the chassis.
Pull all excess cabling out of the airfl ow path or use shorter cables.
4. The control panel LEDs inform you of system status. See Chapter 4 System
Interface for details on the LEDs and the control panel buttons.
Figure 6-4: Air Shroud Installation
6-5
Chapter 6: Advanced Chassis Setup
Advertisement
Table of Contents
