Table of Contents
Advertisement
IPMB
A System Management Bus header for
IPMI 2.0 is located at JIPMB1. Connect
the appropriate cable here to use the
2
IPMB I
C connection on your system.
T-SGPIO 1/2 Headers
Two SGPIO (Serial-Link General
Purpose Input/Output) headers are
located on the serverboard. These
headers support Serial_Link interface
for onboard SATA connections. See
the table on the right for pin defi nitions.
DOM Power Connector
A power connector for SATA DOM
(Disk_On_Module) devices is located
at JSD1. Connect an appropriate cable
here to provide power support for your
DOM devices.
Standby Power Connector
The Standby Power connection
header is located at JSTBY1 on the
serverboard. See the table on the right
for pin defi nitions. (You must also have
a cable to use this feature.)
Chapter 5: Advanced Serverboard Setup
IPMB Header
Pin Defi nitions
Pin# Defi nition
1
2
3
4
SGPIO Header Pin Defi nitions
(T-SGPIO1/T-SGPIO2)
Pin# Defi nition
1
NC
3
Ground
5
Load
7
Clock
(NC = No Connection)
DOM Power
Pin Defi nitions
Pin#
1
2
3
Standby Power
Pin Defi nitions
Pin#
1
2
3
5-23
(JIPMB1)
Data
Ground
Clock
No Connection
Pin# Defi nition
2
Data In
4
Data Out
6
Ground
8
NC
Connector
Defi nition
+5V
Ground
Ground
Defi nition
+5V Standby
Ground
Wake-up
Advertisement
Table of Contents
