Supero SUPERSERVER 1027R-N3RF User Manual page 78

SUPERSERVER
LAN Enable/Disable
JPL1 enables or disables the GLAN
Port1/GLAN Port2 on the serverboard.
See the table on the right for jumper
settings. The default setting is Enabled.
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system moni-
tor that can reboot the system when
a software application hangs. Close
Pins 1-2 to reset the system if an ap-
plication hangs. Close Pins 2-3 to gen-
erate a non-maskable interrupt signal
for the application that hangs. See the
table on the right for jumper settings.
Watch Dog must also be enabled in
the BIOS.
VGA Enable/Disable
Jumper JPG1 allows the user to
enable the onboard VGA connector.
The default setting is 1-2 to enable the
connection. See the table on the right
for jumper settings.
BMC Enable
Jumper JPB1 allows you to enable
the embedded the Renesas BMC
(Baseboard Management) Controller
to provide IPMI 2.0/KVM support on
the serverboard. See the table on the
right for jumper settings.
I2C Bus to PCI-Exp. Slots
2
Jumpers JI C1 and JI
to connect the System Management
2
Bus (I C) to PCI-Express slots. The
default setting is Open to disable the
connection. See the table on the right
for jumper settings.
1027R-N3RF USER'S MANUAL
2
C2 allow you
LAN Enable/Disable
Jumper Settings (JPL1)
Jumper Setting
Pins 1-2
Pins 2-3
Watch Dog Enable/Disable
Jumper Settings (JWD)
Jumper Setting
Pins 1-2
Pins 2-3
Open
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2
Pins 2-3
BMC Enable/Disable
Jumper Settings (JPB1)
Jumper Setting
Pins 1-2
Pins 2-3
I2C to PCI-Exp
Jumper Setting
Jumper Setting
Closed
Open
5-26
Defi nition
Enabled (default)
Disabled
Defi nition
Reset
NMI
Disabled
Defi nition
Enabled
Disabled
Defi nition
BMC Enable
Normal (Default)
Defi nition
Enabled
Disabled (Default)