Table of Contents
Advertisement
Note: You must have RAID set up to enable the hot-swap capability of the SATA
drives. Documentation on RAID setup guidelines can be found on our web site.
Onboard Controllers/Ports
The color-coded I/O ports on the X9DRW-3F include two COM ports (one header
and one port), a VGA (monitor) port, eight USB 2.0 ports (4x rear, 1x header for four
front panel), two gigabit Ethernet ports and one dedicated IPMI LAN port.
Note: For more information on IPMI confi guration, please refer to the IPMI User's
Guide posted on our website at http://www.supermicro.com/support/manuals/
Graphics Controller
The X9DRW-3F features an integrated Renesas Base-board Controller (BMC) chip,
which also acts as a video controller.
Other Features
Other onboard features that promote system health include onboard voltage
monitors, auto-switching voltage regulators, chassis and CPU overheat sensors,
power management, AC power loss recovery, virus protection and BIOS rescue.
1-3
Server Chassis Features
The SC116TS-R700WBP is Supermicro's third-generation 1U chassis and features
ten 2.5" hard drive bays and two high-effi ciency power supplies. The following is a
general outline of the main features of the SC116TS-R700WBP chassis.
System Power
When confi gured as a SuperServer 1027R-N3RF, the SC116TS-R700WBP chassis
includes two redundant hot-swappable 700 Watt power supplies. In the unlikely
event your power supply fails, replacement is simple and can be done without tools.
Hard Drive Subsystem
The SC116TS-R700WBP chassis was designed to support ten hot-swap SATA
hard drives.
PCI Expansion Slots
A riser card (RSC-R1UW-2E16-O-P) on the left side of the chassis can support
two full-height, 6.6" length PCI-E 3.0 x16 cards. See section 5-6 for further details.)
1-3
Chapter 1: Introduction
Advertisement
Table of Contents
