Installing The Air Shroud - Supero 1122GG-TF User Manual

6-4

Installing the Air Shroud

Air shrouds concentrate airflow to maximize fan efficiency. The SC118G chassis air
shroud does not require screws to set up
Note: When installilng two GPU cards, the MCP-310-81803-0B air shroud must be
used. This air shroud is sold separately. Information is available on the Supermicro
Web site at http://www.supermicro.com. Installation of the MCP-310-81803-0B air
shroud is identical to the installation of a standard air shroud, which is described
below.
Installing the Air Shroud
1. Position the air shroud in the chassis as illustrated below.
2. Align the notch (A) on the air shroud with the pin (B) on the riser card bracket.
3. Slide the pin (B) into the back of the notch (A)
4. Lower the front of the air shroud over the fan housing, sliding the front notches
(C) over the pins on the fan housing (D).
Figure 6-5. Installing the Air Shroud
1
C
1
D
Chapter 6: Advanced Chassis Setup
1
A
1
D
6-7
1
B