Control Panel - Supero SUPERSERVER 1027R-N3RF User Manual

SUPERSERVER 1027R-N3RF USER'S MANUAL
Power Supplies
COM1 Port
6-2

Control Panel

The control panel (located on the front of the chassis) must be connected to the JF1
connector on the serverboard to provide you with system status indications. These
wires have been bundled together as a ribbon cable to simplify the connection.
Connect the cable from JF1 on the serverboard to the appropriate header on the
Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1
on both connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System
Interface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Setup."
Figure 6-1. Chassis: Front and Rear Views
Hot-Swap Drive Bays (10)
IPMI Port
USB Ports
PCI Expansion Slots (w/ Riser Cards)
Ethernet Ports
6-2
Control Panel
VGA Port