Table of Contents
Advertisement
5-4
DVD-ROM Drive Installation
The SC119 chassis models support an optional DVD-ROM.
Installing or Replacing a DVD-ROM Drive
1. Power down the system and disconnect the power cords from the rear of the
power supplies. Remove the chassis cover as described in Section 5-2.
2. Unplug the drive's power and data cables from the motherboard and/or back-
plane.
3. If installing a DVD-ROM for the first time: Unlock the mini-bezel lock
scew and remove the mini-bezel (grate) from the drive bay The bezel can be
removed by pulling out the hard drive beneath the DVD-ROM, then pulling
the mini-bezel forward. When installing or removing a DVD-ROM drive, the
mini-bezel lock screw must be removed and the drive tray must be completely
seperated from the chassis.
If replacing an existing DVD-ROM: Pull the DVD-ROM drive tray from the
front of the chassis.
4.
Remove the DVD-ROM from the drive tray by removing the drive screws,
then secure the replacement DVD-ROM into the drive tray, using the drive
screws.
5. Reattach the drive tray to the chassis by replacing the mini-bezel lock screw,
and tightening it from inside the chassis.
6. Reconnect the data and power cables.
7. Replace the chassis cover (replace the server in the rack, if necessary) and
power up the system.
Figure 5-4: Installing the DVD-ROM Drive
Chapter 5 Chassis Setup and Maintenance
5-5
Advertisement
Table of Contents
