Hitachi TAGMASTORE MK-90RD011-25 User Manual page 365

Error Code Error Message
EX_ENXCTG No CT groups left
for OPEN Vol use.
EX_ENQCTG Unmatched CTGID
within the group
EX_ENPERM Permission denied
with the LDEV
EX_ENQSIZ Unmatched volume
size for pairing
EX_ERPERM Permission denied
with the RAID
EX_ESVOLD SVOL denied due to
be disabling
EX_ENOSUP Micro code not
supported
EX_EPRORT Mode changes
denied due to
retention time
EX_ESPERM Permission denied
with the SLPR
EX_ENOPOL Not enough Pool in
RAID
Condition
An available CT group for OPEN
Volume does not exist (TrueCopy
Async or ShadowImage).
The CT group references within a
group do not have an identical
CTGID.
A device mentioned in the
configuration file does not have a
permission for a pair-operation.
Size of a volume is unsuitable
between the remote and local
volume.
A storage system (RAID) mentioned
in the configuration file does not
have a permission for CCI.
A target volume for SVOL is denied
to become SVOL via LDEV
guarding.
The storage system does not
support a function for CCI.
A target volume is denied to be
changing due to retention time via
LDEV guarding.
A specified command device does
not have a permission to access
other SLPR.
Could not retain the pool for
executing a command due to be
exceeded the threshold rate.
Hitachi Command Control Interface (CCI) User and Reference Guide
Recommended Action
Please confirm whether all CT groups are already
used by mainframe volumes (TC and TC390
Async, SI and SI390).
Please confirm the CTGID using the pairvolchk
command and/or confirm that group references
within the configuration file (HORCM_CONF)
refer to the same CT group.
Please confirm if a device which a pair-operation
was permitted by using the pairdisplay or
'raidscan -find verify' command.
Please confirm volume size or number of LUSE
volume using the 'raidscan -f' command, and
make sure the volume sizes are identical.
Please confirm if the type of storage system is
permitted for a CCI by using the 'inqraid -CLI' and
'raidqry -h' commands.
Please confirm whether a target volume is setting
to SVOL disabling by using 'inqraid -fl' or
'raidvchkscan -v gflag' command.
Please confirm the microcode version by using
the 'raidqry -l' command.
Please confirm the retention time for a target
volume using 'raidvchkscan -v gflag' command.
Please make the SLPR so that the target port and
the command device belongs to the same SLPR.
Please deletes unnecessary/earlier generations
paired volume, or re-synchronizes
unnecessary/earlier generations split volume.
Value
215
214
213
212
211
209
210
208
207
206
347