Hitachi TAGMASTORE MK-90RD011-25 User Manual page 177

Two Instances. To start up two instances of CCI on a OpenVMS
1. Create the configuration definition files (see section 3.4).
For a new installation, the configuration definition sample file is supplied
(SYS$POSIX_ROOT:[HORCM.etc]horcm.conf). Copy the file twice, once for each instance.
$ COPY SYS$POSIX_ROOT:[HORCM.etc]horcm.conf SYS$POSIX_ROOT:[etc]
horcm0.conf
$ COPY SYS$POSIX_ROOT:[HORCM.etc]horcm.conf SYS$POSIX_ROOT:[etc]
horcm1.conf
Edit these two files according to the system configuration using a text editor (e.g., eve).
Register the port name (service) of the configuration definition file in
"SYS$SYSROOT:[000000.TCPIP$ETC]SERVICES.DAT".
horcm0 xxxxx/udp. Where "xxxxx" denotes a port number.
horcm1 yyyyy/udp.
Each instance should have a unique port number.
The port number can be directly specified without registering it in
"SYS$SYSROOT:[000000.TCPIP$ETC]SERVICES.DAT".
2. Execute the HORCM startup command.
$ spawn /nowait /process=horcm0 horcmstart 0
$ spawn /nowait /process=horcm1 horcmstart 1
Note: The subprocess(HORCM) created by SPAWN will be terminated when the terminal
will be LOGOFF or the session will be terminated. If you want independence Process to
the terminal LOGOFF, then use "RUN /DETACHED" command (Refer to item (4) in
section 3.5.1).
3. Set the HORCM instance numbers in the environment in which the command is to be
executed:
$ HORCMINST:=X
4. Confirm the configuration using a RAID Manager command.
Set the log directory (HORCC_LOG) in the command execution environment as required.
Note: If the log directory under SYS$POSIX_ROOT is shared with other nodes, the log
directory of Horc Manager must be set for each node. The log directory of Horc
Manager can be changed by setting the parameter of horcmstart (see Table 4.35).
When the command issued is for HOMRCF, set the environment variable (HORCC_MRCF).
$ HORCC_MRCF:=1
$ pairdisplay -g xxxx Where "xxxx" denotes a group name.
Note: If a system configuration change or a RAID configuration change causes this file to
change (e.g., cache size change, microcode change), these changes will not take effect until
you stop HORCM (horcmshutdown 0 1) and restart HORCM (horcmstart 0 and horcmstart 1).
Use the "-c" option to pairdisplay command to verify that there are no configuration errors.
Where "xxxxx" denotes a port number.
where "X" denotes an instance number (0 or 1)
Hitachi Command Control Interface (CCI) User and Reference Guide
®
system:
159