Using The Cli To Configure Ethernet Settings; Table 8. Cli Commands For Ethernet Settings - D-Link DWL-3500AP - AirPremier Wireless Switching 108G Access Point Administrator's Manual

Using the CLI to Configure Ethernet Settings

Use the commands in
more information about each setting, see the description for the field in

Table 8. CLI Commands for Ethernet Settings

Action
Get the DNS Name
Set the DNS Name
Get Current Settings for the
Ethernet (Wired) Internal Interface
Set the management VLAN ID
View untagged VLAN information
Enable the untagged VLAN
Disable the untagged VLAN
Set the untagged VLAN ID
View the connection type
Use DHCP as the connection type
Use a Static IP as the connection
type
Set the Static IP address
Set a Subnet Mask
Set the Default
Gateway
View the DNS Nameserver mode
Dynamic= up
Manual=down
Table 8 to view and set values for the Ethernet (wired) interface. For
Command
get host id
set host id <host_name>
For example:
set host id vicky-ap
get management
set management vlan-id <1-4094>
get untagged-vlan
set untagged-vlan status up
set untagged-vlan status down
set untagged-vlan vlan-id <1-4094>
get management dhcp-status
set management dhcp-client status up
set management dhcp-client status down
set management static-ip <ip_address>
Example:
set management static-ip 10.10.12.221
set management static-mask <netmask>
Example:
set management static-mask 255.0.0.0
set static-ip-route gateway <ip_address>
Example:
set static-ip-route gateway 10.254.0.1
Note that there is no need to set static-ip-route mask or static-
ip-route destination when setting the default gateway.
In general, the static-ip-route mask should be set as the
netmask for the destination net: "255.255.255.255" for a host
or left as "0.0.0.0" for the default route.
get host dns-via-dhcp
3 Installing the Access Point
Table 7.
Configuring the Ethernet Interface 33