Vap Configuration From The Cli; Vap Configuration Using Snmp - D-Link DWL-8600AP Administrator's Manual

Software User Manual
12/10/09
characters.
8. Click Update to update the AP with the new settings.
VAP C
ONFIGURATION FROM THE
1. Connect to the AP by using Telnet, SSH, or a serial connection.
2. Enable VAP 1.
set vap vap1 status up
3. Set the VLAN ID to 2.
set vap vap1 vlan-id 2
Note: The previous command sets the VLAN ID to 2 for VAP 1 on both radios. To set the VLAN ID for VAP 1
on radio one only, use the following command:
4. Set the SSID to Marketing.
set interface wlan0vap1 ssid Marketing
5. Set the Security Mode to WPA Personal.
set interface wlan0vap1 security wpa-personal
6. Allow WPA2 clients, and not WPA clients, to connect to the AP.
set bss wlan0bssvap1 wpa-allowed off
set bss wlan0bssvap1 wpa2-allowed on
7. Set the Cipher Suite to CCMP (AES) only.
set bss wlan0bssvap1 wpa-cipher-tkip off
set bss wlan0bssvap1 wpa-cipher-ccmp on
8. Set the Pre-shared key.
set interface wlan0vap1 wpa-personal-key JuPXkC7GvY$moQiUttp2
If the shared secret keys includes spaces, place the key inside quotation marks.
9. Use the following commands to view and verify the settings.
get interface wlan0vap1 detail
get vap vap1 detail
VAP C
ONFIGURATION
1. Load the DLINK-WLAN-ACCESS-POINT-MIB module.
2. From the MIB tree, navigate to the objects in the apVap table.
3. Walk the apVapDescription object to view the instance ID for VAP 1 (wlan0vap1).
VAP 1 on Radio 1 is instance 3.
4. Use the apVapStatus object to set the status of VAP 1 to up (1).
5. Use the apVapVlanID object to set the VLAN ID of VAP 1 to 2.
6. Navigate to the objects in the apIfConfig table.
34CSFP6XXUAP-SWUM100-D13
CLI
U SNMP
SING
set vap 1 with radio wlan0 to vlan-id 2
D-Link UAP
.
Configuring a VAP Page 117