Figure 20: Modifying Snmp Settings; Table 30: Snmp Settings - D-Link DWL-8600AP Administrator's Manual

Software User Manual
12/10/09
Field
SNMP
Enabled/Disabled
Read-only
community name
(for permitted GETs)
Port number the SNMP
agent will
listen to
34CSFP6XXUAP-SWUM100-D13

Figure 20: Modifying SNMP Settings

Table 30: SNMP Settings

Description
You can specify the SNMP administrative mode on your network. By default SNMP is
enabled. To enable SNMP, click Enabled.To disable SNMP, click
mode, you must click Apply to save your configuration changes.
Note: If you disable SNMP, all remaining fields on the SNMP page are is disabled. This is a
global SNMP parameter which applies to SNMPv1, SNMPv2c, and SNMPv3.
Enter a read-only community name.
The community name, as defined in SNMPv2c, acts as a simple authentication mechanism
to restrict the machines on the network that can request data to the SNMP agent. The name
functions as a password, and the request is assumed to be authentic if the sender knows the
password.
The community name can be in any alphanumeric format.
By default an SNMP agent only listens to requests from port 161. However, you can configure
this so the agent listens to requests on another port.
Enter the port number on which you want the SNMP agents to listen to requests.
Note: This is a global SNMP parameter which applies to SNMPv1, SNMPv2c, and
SNMPv3.
Disabled. After changing the
Configuring SNMP on the Access Point
D-Link UAP
Page 69