Replacing The Toner Cartriges; Replacing The Oil Cartridge And The Cleaning Roller - Sagem MF 3850 MF 3830 User Manual

Maintenance.fm Page 15 Lundi, 11. juin 2001 5:43 17
Maintenance
DRUM JAM
REPLACE FUSER
INSERT GAUGE CARD
REPLACE RIBON
INSERT GAUGE CARD
REPLACE KIT
INSERT GAUGE CARD
REPLACE BLACK
TONER
BLACK, YELLOW,
MAGENTA OR CYAN
INSERT GAUGE CARD
CLOSE FRONT COVER
CLOSE UPPER COVER
CLOSE REAR COVER
NO PRINTER
PAPER EMPTY
OVERHEATING
CHECK FUSER
PAPER JAM
INSIDE
Date en cours : 11 juin 2001
\\Sct31nt3\doc 31nt3 mac\SAGEM FM\DOC EN COURS\MFC 23260972-6_38xx Sagem GB\Maintenance.fm
Open the cover.
Remove the sheet at the OPC cartridge level.
Replace the heater (call the customer service)
Replace the ribbon.
To proceed, refer to paragraph Setting the OPC cartridge,
page 1/3.
Change consumable kit
(oil cartridge, cleaning ribbon)
To proceed, refer to the following paragraph:
Replacing the oil cartridge and the cleaning roller, p. 6/4
Replace the toner cartridge.
To proceed, refer to paragraph Replacing the toner cartriges,
page 6/2.
Close the front cover of the printer.
Close the upper cover of the printer.
Close the back cover of the printer.
Check the printer to scanner connection.
(refer to paragraph Printer connection, page 1/8).
Install the paper tray.
Fill in the tray with the required format paper.
Wait until the printer is available again.
Check the heater (call the customer Service).
Open the tray.
Remove the jammed sheet.
6-15