Connecting The Sip Paging Adapter; Connection Options - CyberData 11233 Operation Manual

2.3 Connecting the SIP Paging Adapter

Before you connect the SIP Paging Adapter, be sure that you have received all of the parts
described in

2.3.1 Connection Options

See
Adapter.
Pin
1
2
3
4
5
6
7
a. The 600-Ohm audio output of the page port is also suited for interfaces with lower input
b. 1 Amp at 30 VDC for continuous loads
CyberData Corporation
Section 2.1, "Parts
Figure 2-3 and Table 2-1
Line In
Table 2-1. Page Port Output Connections
Description
Fault Sense Input (Common). See
(Common/Sense)".
Fault Sense Input (Sense). See
(Common/Sense)".
Positive 600-Ohm Audio Output
Ohm Audio Output/Audio Ground
Negative 600-Ohm Audio Output.
Ohm Audio Output/Audio Ground
Audio Ground Reference. See
Output/Audio Ground Reference".
b
Relay Contact - Common
Open)".
Relay Contact - Normally Open
(Common/Normally Open)".
impedances.
List".
for the connection options that are available for the SIP Paging
Figure 2-3. Connection Options
Line Out Page Port Output
Pin 1 Pin2 Pin 3 Pin 4 Pin 5
Section 2.3.1.1, "Pin 1 and 2—Fault Sense Input
Section 2.3.1.1, "Pin 1 and 2—Fault Sense Input
a
. See Section 2.3.1.2, "Pin 3, 4, and 5—Positive/Negative 600-
Reference".
a
. See Section 2.3.1.2, "Pin 3, 4, and 5—Positive/Negative 600-
Reference".
Section 2.3.1.2, "Pin 3, 4, and 5—Positive/Negative 600-Ohm Audio
. See Section 2.3.1.3, "Pin 6 and 7—Relay Contact (Common/Normally
b
. See Section 2.3.1.3, "Pin 6 and 7—Relay Contact
930622F
Setting Up the SIP Paging Adapter
Connection Options
48VDC
Power
Pin 6 Pin 7
Operations Guide
7