Confirm The Ip Address And Test The Audio; Adjust The Volume - CyberData 11095 Operation Manual

2.2.11 Confirm the IP Address and Test the Audio

2.2.11.1 RTFM Switch
When the Loudspeaker Amplifier is operational and linked to the network, use the Reset Test
Function Management (RTFM) switch
and confirm the Loudspeaker Amplifier's IP Address and test the audio to verify that it is working.
Announcing the IP
To announce a Loudspeaker Amplifier's current IP address:
Address
• Press and hold the RTFM switch for a couple of seconds and then release it.
Restoring the To restore the factory default settings, complete the following steps:
Factory Default
Settings
1. Press and hold the RTFM switch until you hear the Paging Amplifier announce the words,
"restoring defaults" and "rebooting".
2. Release the RTFM switch. The Paging Amplifier will be restored to the factory default settings.

2.2.12 Adjust the Volume

There are two ways to adjust the volume for the Loudspeaker Amplifier:
•
•
Operations Guide
Caution
Equipment Caution: Pressing and holding the RTFM switch for more than five
seconds will restore the V2 Paging Amplifier to the factory default settings. See
the "Restoring the Factory Default
GENERAL ALERT
The Speaker Volume (0-9)
The external Volume dial on the Loudspeaker Amplifier face
(Figure 2-19) on the Loudspeaker Amplifier face to announce
Figure 2-19. RTFM Switch
Settings" section.
setting on the Device Configuration page
930360J
Installing the VoIP V2 Loudspeaker Amplifier
Loudspeaker Amplifier Setup
CyberData Corporation
18
RTFM switch