Electrical Installation; What This Chapter Contains; General Cabling Instructions; Ethercat® Connections - ABB RECA-01 User Manual

Electrical installation

What this chapter contains

This chapter contains

• general cabling instructions

• EtherCAT® connections.
WARNING! Before installation, switch off the drive power supply.
Wait 5 minutes to ensure that the capacitor bank of the drive is
discharged. Switch off all dangerous voltages connected from
external control circuits to the inputs and outputs of the drive.
General cabling instructions
Arrange the bus cables as far away from the motor cables as
possible. Avoid parallel runs. Use bushings at cable entries.
EtherCAT® connections
The network cables can be connected to the two RJ45 connectors
(X1 and X2) on the RECA-01 module. Standard CAT 5 UTP,
CAT 5 FTP or CAT 5 STP cables can be used. In case CAT 5
STP is used, the cable shield is internally connected to the drive
frame through the module.
Electrical installation
27