Kramer VS-3232DN User Manual page 43

8.2.6 Config Menu—Interface Reply Configuration
This option lets you switch the Reply configuration on or off. Setting Reply to on
causes all interfaces that are set to on to accept and execute commands, and also
to reply. Setting Reply to off causes all interfaces that are set to on to accept and
execute commands, but not to reply.
To switch the Reply configuration on or off:
1. Press MENU twice.
The following message is displayed:
start configuration menu
MENU to view setup ENT to change them
2. Press MENU until the following is displayed:
interface REPLY configuration
current interface REPLY – ON
This indicates the current Reply configuration status.
3. Press ENT to enter the Reply Submenu.
The following is displayed:
interface REPLY configuration
1:turn REPLY ON
4. Press 1 to switch Reply on or 2 to switch it off.
5. Press TAKE to confirm the action.
A message is displayed indicating the new status of the Reply configuration.
After a few seconds the next option on the Config Menu is displayed.
8.2.7 Config Menu—Protocol Configuration
The VS-3232DN supports Kramer Protocol 2000 and Protocol 3000.
To switch from Protocol 3000 (default) to Protocol 2000:
1. Press MENU twice.
The following message is displayed:
start configuration menu
MENU to view setup ENT to change them
VS-3232DN - Using the Configuration Menus
2:never REPLY
39