Kramer VS-3232DN User Manual page 11

# Feature
1
2
3
Double-
4
function
Selector
5
Button
6
Area
7
8
9 BREAKAWAY Button
10 DEFAULT SETUP Button
11 OUTPUTS/INPUTS LCD Display
12 IR Receiver
13 IR LED
14 TAKE Button
15 MENU Button
16 LOCK Button
17 Power Supply
18 Power Supply
19 POWER LED
20 ERROR LED
VS-3232DN - Defining the VS-3232DN 32x32 Digital Matrix Switcher
Function
ESC Press to exit the current operation
EDID Press to assign EDID channels
STO Press to store the current setup in the a preset. After pressing the MENU button, this button
lights and is enabled
ALL Press to connect an input to all outputs. After pressing the MENU button, this button lights and
Menu
is enabled
Button
OFF Press to turn off an output. After pressing the MENU button, this button lights and is enabled
Functions
RCL Press to recall a preset. After pressing the MENU button, this button lights and is enabled
DELAY Press to set the delay between confirming an action and the execution of the action
ENT Press to complete the input-output setup when using a one-digit number instead of two digits.
Press to enter the options in a setup menu. (For example, to enter input 5, you can either press
05 or 5, ENT)
Press to exit a Menu (see
Press to recall the default setup (see
Displays the outputs (upper row) switched to the selected inputs (lower row), (see
Section 7.1
Infrared remote control sensor
Lights yellow when receiving commands from the IR remote control transmitter
Press to confirm actions (see
Press once to enable the ALL, OFF STO and RCL buttons (see
enter the configuration menu (see
When in a Menu, press to cycle through the menu items
Press and hold for approximately 2 sec to lock/unlock the front panel buttons (see
Supplies power to the chassis and cards (see
Supplies power to the device
Lights green when the device is powered on
Lights red when there is a fault with the power supply
Section 8 )
Section 7.4.5
). Displays user interface messages and menus
Section 7.3.2 )
Section 8.2
7
)
Section 8). Press again to
).
Section 7.6 )
Section 7.5 )