Using The Dvs5.1 With A Remote Control - Zektor DVS5.1 Owner's Manual

Using the DVS5.1 with a Remote Control

Remote operations of the DVS5.1 are accomplished through the use of just about any remote con-
trol. A remote control is not supplied with the DVS5.1, yet the versatile programming modes of the
DVS5.1 allows the DVS5.1 to work with virtually any remote control. The next section "Program-
ming your Remote Control" on page 7, describes how to setup your remote control. After your re-
mote control is programmed, the following describes the pre-programmed functions of the DVS5.1.
There are 12 separate remote controlled commands understood by the DVS5.1. They are:
• P
T
OWER OGGLE
CBL /
TV VCR
SAT
1 2
4
5
8
7
0
PIP
VOL
+ +
_
.The DVS5.1 can be toggled from standby to power on, and back to standby
using a single button of the remote.
• S
it will power on and then select input 1.
• S
POWER
it will power on and then select input 2.
DVD RCVR
• S
it will power on and then select input 3.
3
• S
it will power on and then select input 4.
6
• S
9
it will power on and then select input 5.
• A
ENT
DIO
switch only the audio stream.
• P
pressing a single button of the remote. Once the DVS5.1 is in
standby mode, further presses of the P
be ignored. This command is useful when using the "macro"
feature of some programmable remote controls, and is used
when it is unknown whether or not the DVS5.1 is already in
standby mode.
• P
CH
pressing a single button of the remote. Once the DVS5.1 is
powered on, further presses of the P
_
ignored. This command is useful when using remote controls
that allow "macro" programming, where it is unknown whether
or not the DVS5.1 is already powered on.
• S
play modes. They are: Bright all the time. Dim all the time.
Bright for 4 seconds after any keypress, and then automati-
cally dim.
• S
selected, then this command will cause input 1 to be selected.
• S
lected, then this command will cause input 5 to be selected.
1. Select input 1. If the DVS5.1 is in standby mode,
I
ELECT N
2. Select input 2. If the DVS5.1 is in standby mode,
I
ELECT N
3. Select input 3. If the DVS5.1 is in standby mode,
I
ELECT N
4. Select input 4. If the DVS5.1 is in standby mode,
I
ELECT N
5. Select input 5. If the DVS5.1 is in standby mode,
I
ELECT N
. Audio break away select key. Pressing the A
B
UDIO REAK
key, followed by any of the S
B
REAK
OFF. The DVS5.1 can be set to standby mode by
OWER
ON. The DVS5.1 can be powered on from standby by
OWER
. Toggles through three different bright/dim dis-
D M
ET IM ODE
+. Select the next higher input. If input 5 is currently
ELECT
-. Select the next lower input. If input 1 is currently se-
ELECT
6
keys, will
I
ELECT N
OFF button will
OWER
ON button will be
OWER
-
U