Programming Your Remote Control; Setting Up Your Universal Remote Control - Zektor HDS4.2 Owner's Manual

Programming your Remote Control

Setting up your Universal Remote Control

For remote control operations, the HDS4.2 requires either a Universal Remote control to be pro-
grammed as one of eight pre-programmed devices, or alternatively, the HDS4.2 can be taught to
use most existing remote controls.
The simplest way to begin using the HDS4.2, is to program your Universal Remote control to act
like the remote used to control a Yamaha VCR. Once this is done you will be able to immediately
start using your HDS4.2.
Check your remote's user manual for instructions on programming your remote control.
The following table shows the Yamaha VCR codes for a few different brands of Universal Remote
Controllers:
Make
Sony
One For All
Sanyo
GE / RCA
X10
Zenith / Phillips /
Magnavox
Device Code
VCR 040
VCR 0038
VCR 238
VCR 009
VCR 022
VCR 025
6