Sealing - Cannon FITZPIB User Instructions

Sealing

10.Disconnect the switch loom connector from the loom plug.
Refer figure 20.
20
11. Remove the inner glass. Slacken off screws in top clamp and
remove side clamps. Refer figure 21.
21
12. All gaps between heater case and fireplace are to be sealed.
Seal with foam tape around top and sides of heater flange as
required. Refer figure 22.
Seal with fibreglass between bottom of heater case and base
of fireplace.
22
If using a spacer to compensate for lack of chimney depth
ensure the tape is placed on the outer rim of the spacer flange.
Refer figure 23 on next page.
13