Table of Contents
Advertisement
Wall-mounting the Switch
The switch can be mounted either vertically or horizontally on a wall using
the keyholes on the bottom of the chassis. For wall-mount installation, you
will need two panhead screws and plastic anchors.
To wall-mount the switch, perform the following procedure:
1.
If attached, remove the rubber feet, data cables, and power cord from the
switch.
2.
Select a wall location for the device.
3.
Install the plastic anchors and panhead screws 100 millimeters (3.94
inches) apart on the wall.
4.
Position the device onto the wall screws. If you are mounting the switch
horizontally, position the switch so that the ports are facing down and the
LEDs are facing up. If you are mounting the switch vertically, position the
switch so that the ports are facing to the left and the LEDs to the right.
5.
Connect the twisted pair cables to the RJ-45 connectors.
6.
Connect the fiber optic cable to the fiber optic port.
7.
Set the 100FX DUPLEX switch on the fiber optic port to either HALF for
half-duplex or FULL for full-duplex operation. The capabilities of the end-
node connected to the fiber optic port will determine the correct setting for
this switch. If the end-node is capable of only half-duplex, set the switch to
HALF. If the end-node is capable of full-duplex, set the switch to FULL.
Warning
The power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord.
8.
Power ON the switch by plugging one end of the power cord to the back of
the switch and the other end of the power cord to a power outlet. The PWR
LED should be green. If the LED is OFF, refer to "Troubleshooting" on
page 19 for assistance.
9.
Power ON the end-nodes connected to the ports on the switch.
10. Check the LNK/ACT LED for each port. The LED should be green or
blinking. If the LED is OFF, refer to "Troubleshooting" on page 19 for
assistance.
The switch is now ready for use.
16
$
9
Advertisement
Table of Contents
