Table of Contents
Advertisement
Chapter 2: Installation
Mounting the Switch on a Wall
36
You can mount the AT-FS708/POE Fast Ethernet switch on the wall in a
vertical position using the mounting brackets that are shipped with the
switch. The wall-mounting screws, plastic anchors, and other materials
necessary to mount the switch on a wall are not provided.
To mount the switch on a wall, perform the following procedure:
1. If attached, remove the rubber feet using a flat-head screwdriver.
2. Select a wall location for the switch.
3. Turn the switch over and attach a mounting bracket (provided) to each
side of the switch using the bracket mounting screws (provided), as
shown Figure 6.
Figure 6. Attaching Brackets for Wall Mounting
Caution
The attached mounting brackets must be used to securely mount
the device on the wall.
4. Position the switch on the wall with the top of the switch against the
wall and the ports facing up.
Caution
Make sure that the AT-FS708/POE Fast Ethernet switch is always
mounted on the wall with the front panel facing up and the back
panel facing down.
777
E15
777
Advertisement
Table of Contents
