Planning The Installation - Allied Telesis AT-FS713FC/xx Installation Manual

Planning the Installation

Be sure to observe the following guidelines when planning the installation of
your switch.
q
The end-node connected to the 100Base-FX fiber optic port must be
able to operate at 100 Mbps.
q
The end-node connected to a 10/100Base-TX twisted pair port must be
able to operate at 10 or 100 Mbps.
q
The end-node connected to a port on the switch can be a network
adapter card, repeater, router, hub, or another switch.
q
Refer to Table 4 for the cabling specifications for the twisted pair
ports.
Table 4 10/100Base-TX Twisted Pair Cabling Specifications
Operating Mode
10Base-T
100Base-TX
q
Refer to Table 5 for the cabling specifications for the fiber optic port
operating in full-duplex mode.
Table 5 100Base-FX Fiber Optic Cabling Specifications (Full-duplex)
Model Fiber Optic Cable
All models 50/125 or 62.5/125
micron multimode
Note
Refer to "Fiber Optic Port Specifications" on page 22 for additional
information on the fiber optic port.
AT-FS713FC/xx and AT-FS717FC/xx Series Installation Guide
Twisted Pair Cable
Shielded or unshielded Category 3 or better
Shielded or unshielded Category 5 or better
Maximum Operating
Distance
2 km (1.2 mi)
Maximum Operating
Distance
100 m (328 ft)
100 m (328 ft)
Maximum
Allowable Loss
Budget
13 dB at 1310 nm
13