Tube wheel
Tubeless wheel
EWA2DM1017
WARNING
After extensive tests, the tires listed below
have been approved by MBK industrie for
this model. The front and rear tires should al-
ways be by the same manufacturer and of
the same design. No guarantee concerning
handling characteristics can be given if a tire
combination other than one approved by
MBK industrie is used on this vehicle.
Front tire
Size
120/70–15 M/C 56P(METZELER)-
56S(MICHELIN)
Manufacturer/model
METZELER / FEELFREE
Manufacturer/model
MICHELIN / CITYGRIP
Rear tire
Size
140/70–14 M/C 68P(METZELER)-
68S(MICHELIN)
Manufacturer/model
METZELER / FEELFREE
Manufacturer/model
MICHELIN / CITYGRIP
EWA2DM1006
WARNING
New tires have a relatively low grip on the
road surface until they have been slightly
worn. Therefore, approximately 100 km
should be traveled at normal speed before
any high-speed riding is done.
TIP
For tires with a direction of rotation mark "1":
Install the tire with the mark pointing in the direc-
tion of wheel rotation.
Tube tire only
Tube or tubeless tire
PERIODIC MAINTENANCE
EAS1SD1004
CHECKING THE WHEEL BEARINGS
The following procedure applies to all of the
wheel bearings.
1. Check:
• Wheel bearings
Refer to "CHECKING THE FRONT WHEEL"
on page 4-20 and "CHECKING THE REAR
WHEEL" on page 4-29.
EAS21520
CHECKING AND ADJUSTING THE
STEERING HEAD
1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
TIP
Place the vehicle on a suitable stand so that the
front wheel is elevated.
2. Check:
• Steering head
Grasp the bottom of the front fork legs and
gently rock the front fork.
Binding/looseness → Adjust the steering
head.
3. Remove:
• Lower handlebar holder
Refer to "STEERING HEAD" on page 4-81.
4. Adjust:
• Steering head
▼
▼▼▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
a. Remove the upper ring nut "1", the lock wash-
er "2", the center ring nut "3" and the rubber
washer.
3-15
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼▼▼