Installing The Appliance - Smeg Hob Instructions For The Installer

2. INSTALLING THE APPLIANCE

The appliance must be installed by a qualified technician and in
accordance with the regulations in force.
This appliance may be installed next to walls, one of which must be
higher than the appliance, at a minimum distance of 50 mm from the side
of the appliance, as shown in drawings A and B relative to the
installation classes. Any wall cupboards or ventilation hoods must be at
a distance of at least 750 mm above the work surface.
2.1 Electrical connection
Make sure the voltage and the cross-section of the power supply line
match the specifications indicated on the identification plate positioned in
the storage compartment.
Do not remove this plate for any reason.
Fit the power line with an omnipolar circuit-breaker with a contact
opening gap equal to or greater than 3 mm, in an easily accessible
position close to the appliance.
The appliance has a terminal on the back for electrical connection (see
diagram below). This can be accessed by removing the rear part of the
casing.
44
Instructions for the installer