Smeg Hob Instructions For The Installer page 36

8.7 Setting the cleaning cycle with the electronic analogue
clock
The programmer will automatically set the minimum cleaning cycle
duration (1 hour 30 minutes) as illustrated in figure 1. Press the
keys to increase or decrease the cycle time (the maximum period is 3
hours and 30 minutes). The set minutes will be shown by the internal
segments of the clockface lighting up, while the hours will be shown by
the relevant numbers flashing (1, 2 or 3). Figure 2 shows a period of 2
hours, 30 minutes.
Once the automatic cleaning cycle time has been set, the oven will start
to heat up (approx. 5 seconds after the last action by the user), the oven
thermostat light will start flashing and will become steady once the oven
has reached a temperature of approx. 470°C.
The door lock will be activated within approx. 1 minute after the last
action by the user, shown by the relevant light coming on and the
symbol flashing on the display.
At the end of the automatic cleaning cycle, all the numbers will flash and a
buzzer will sound to indicate the end of the cycle. The door lock light will
remain lit and it will not be possible to open the door until the temperature
inside the oven falls below 300°C. Once pyrolysis is complete, set the function
selector to off.
To activate pyrolysis with delayed start, set the timer as for a normal
programmed cooking operation, see " 3.2.3 Programming".
76
Instructions for the user
FUNCTION SELECTOR KNOB
ELECTRONIC ANALOGUE CLOCK
1) 2)
or