Smeg Hob Instructions For Use Manual
  1. Manuals
  2. Brands
  3. Smeg Manuals
  4. Hob
  5. Hob
  6. Instructions for use manual
Smeg Hob Instructions For Use Manual

Smeg Hob Instructions For Use Manual

Hide thumbs Also See for Hob:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Instruction Manual, User Manual
1. INSTRUCTIONS FOR USE .............................................................. 30
2. SAFETY PRECAUTIONS ................................................................. 32
3. ENVIRONMENTAL CARE................................................................. 34
4. DESCRIPTION OF THE CONTROLS .............................................. 35
5. USING THE HOB.............................................................................. 36
6. CLEANING AND MAINTENANCE.................................................... 41
7. MOUNTING ONTO FURNITURE ..................................................... 44
8. GAS CONNECTION ......................................................................... 47
9. ADAPTATION TO DIFFERENT TYPES OF GAS ............................ 49
10. ELECTRICAL CONNECTION........................................................... 54
THESE INSTRUCTIONS ARE VALID ONLY FOR THE DESTINATION COUNTRIES
WHOSE IDENTIFYING SYMBOLS ARE INCLUDED ON THE COVER OF THIS
MANUAL.
THIS IS A CLASS 3 BUILT IN HOB.
INSTRUCTIONS FOR THE USER: these contain user advice, the
description of the controls and the correct procedures for cleaning and
maintenance of the appliance.
INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified
technician who must install the appliance, set it functioning and carry out
an inspection test.
@
Further information about the products can be found at www.smeg.com
Contents
29

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Hob and is the answer not in the manual?

Questions and answers

Related Manuals for Smeg Hob

Summary of Contents for Smeg Hob

  • Page 1: Table Of Contents

    INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified technician who must install the appliance, set it functioning and carry out an inspection test. Further information about the products can be found at www.smeg.com...

  • Page 2: Instructions For Use

    Do not leave the appliance unattended during cooking operations where fats or oils could be released. Fats and oils may catch fire. Always check that the control knobs are in the O (off) position when you finish using the hob.

  • Page 3: General Instructions

    General instructions Never place saucepans with bases which are not perfectly flat and smooth on the hob. Never use cookware which extends beyond the external perimeter of the hob.

  • Page 4: Safety Precautions

    General instructions 2. SAFETY PRECAUTIONS Consult the installation instructions for safety standards on electrical or gas appliances and for ventilation functions. In your interests and for your safety the law requires that the installation and servicing of all electrical and gas appliances be carried out by qualified personnel in accordance with the standards in force.
  • Page 5 General instructions This appliance may be used by children from the age of 8 and by people of reduced physical and mental ability or lacking in experience and knowledge, provided they are supervised or instructed on the safe use of the appliance and if they understand the associated risks.

  • Page 6: Environmental Care

    Instructions for disposal 3. ENVIRONMENTAL CARE Our environmental care Pursuant to Directives 2002/95/EC, 2002/96/EC and 2003/108/EC relating to the reduction of the use of hazardous substances in electrical and electronic appliances, as well as to the disposal of refuse, the crossed out bin symbol on the appliance indicates that the product, at the end of its working life, must be collected separately from other refuse.

  • Page 7: Description Of The Controls

    Instructions for the user 4. DESCRIPTION OF THE CONTROLS Control zone All the hob controls are grouped together on the front panel. CONTROL ZONE 3-burner hob 4-burner hob 5-burner hob KNOB DESCRIPTION To light the flame, press the knob and, at the same time, turn it...

  • Page 8: Using The Hob

    D on the hob. Positioning the pan stands The pan stands are provided unassembled on the hob. There are three types of pan stands you must be familiar with in order to position them correctly. 3-burner pan stand...
  • Page 9 Instructions for the user To position each pan stand correctly on its burner, follow the instructions below: 3-burner hob 4-burner hob 5-burner hob At the ends of the legs of the pan stands there are silicone rests with a hole that must be centred onto the...
  • Page 10 Instructions for the user Position the support pan stand on the side burners, centring the fastening pins (1) and (2) and then resting it on the hob. Then position the central pan stand (5-burner model) or the resting pan stand (4-burner model) so that the dent rests on the supporting bar of the support pan stand as shown in the figure.
  • Page 11 During cooking, in order to avoid burns or damage to the counter top and to the glass lid (when present), all pans or griddles must be positioned within the cooking hob perimeter and a minimum distance of 3-4 cm must be maintained from the knobs.
  • Page 12 Instructions for the user Cookware diameters Burner min. and max. Ø (in cm) Auxiliary 7 - 18 Semi-rapid 10 - 24 3 - 4 Rapid 18 - 24 5 - 6 Ultra-rapid 24 - 28 • Do not use griddles or plates to cook or heat food on the ultra-rapid/triple crown burner;...

  • Page 13: Cleaning And Maintenance

    WARNING: For your safety, you are advised to wear protective gloves while performing any cleaning or extraordinary maintenance. Cleaning the hob To keep the hob in good condition it should be cleaned regularly after use. Let it cool first. 6.1.1 Ordinary daily cleaning To clean and preserve surfaces, always use only specific products that do not contain abrasives or chlorine-based acids.
  • Page 14 Crema inox or standard abrasive creams available in shops. To avoid encrustations which are difficult to remove, you are advised to clean the hob every time you finish cooking. Cleaning the components 6.3.1 Knobs The knobs should be cleaned with lukewarm water and washing up liquid.
  • Page 15 The holes C in the burner crowns should be slid over the igniters and thermocouples D on the hob. DO NOT REMOVE THE FASTENING PLATES TO CLEAN THE HOB. 6.3.4 Igniters and thermocouples For correct operation the igniters and thermocouples must always be perfectly clean.

  • Page 16: Mounting Onto Furniture

    Do not fix the hob using silicone as this would make it impossible to remove the hob, if necessary, without damaging it.
  • Page 17 Instructions for the installer Fixing using brackets The figure to the side shows the exact holes to be used to correctly attach the hob to the counter top with brackets. Fix the hob to the unit using the appropriate brackets supplied.
  • Page 18 Keep a minimum distance of 10 mm between the bottom of the appliance and the panel surface (as shown in the figure). If the appliance is instead on an oven installed under the hob, there is no need to install a separating shelf. The oven must be equipped with a cooling fan.

  • Page 19: Gas Connection

    The cooker hob is preset for natural gas G20 (2H) at a pressure of 20 mbar. For supplying it with other types of gas, see chapter "9. ADAPTATION TO DIFFERENT TYPES OF GAS".
  • Page 20 Instructions for the installer Connection with a rigid copper hose The connection to the gas supply network must be made in such a way that it does not cause stresses of any type on the appliance. Carefully screw the adapter unit 4 with double cone to the gas connector 1 of the appliance, placing the supplied seal 3 between them.

  • Page 21: Adaptation To Different Types Of Gas

    In order to replace the nozzles and adjust the burners, the hob top must be removed as described below. Removing the hob top •...

  • Page 22: Burner And Nozzle Characteristics Table

    Instructions for the installer Burner and nozzle characteristics table Rated heating Burner Natural gas – G20 20 mbar capacity (kW) Nozzle diameter Reduced capacity 1/100 mm Auxiliary (1) Semi-rapid (2) Rapid (3) 1050 Rapid (4) 1050 Ultra-rapid (5) 1600 Ultra-rapid (6) 1600 Rated heating...
  • Page 23 Instructions for the installer Adjustment for LPG Unscrew screw C and push air regulator D as far as it will go. Using a 7-mm wrench, remove nozzle E and replace it with the appropriate nozzle, following the instructions in the tables for the type of gas to be used. The nozzle tightening torque must be no more than 3 Nm.
  • Page 24 Rapid (4) Ultra-rapid (5) Ultra-rapid (6) To identify the burners on your hob, refer to the drawings in “9.8 Arrangement of the burners on the cooking hob”. After making the adjustments described above, reassemble the appliance by following the instructions in “9.1 Removing the hob top” in reverse order.
  • Page 25 Instructions for the installer Arrangement of the burners on the cooking hob BURNERS 1 Auxiliary 2 Semi-rapid 3 Rapid 4 Rapid 5 Ultra-rapid 6 Ultra-rapid Lubrication of gas taps Over time the gas taps may become difficult to turn and get blocked. Clean them internally and replace the lubrication grease.

  • Page 26: Electrical Connection

    Make sure that the supply line is suitably earthed. Pass the power supply cable through the back of the unit, taking care that it does not touch the bottom casing of the hob or the oven (if any) installed underneath it.

Table of Contents