Installation Of The Appliance; Installing The Appliance - Smeg Hob Instructions For The User

2. INSTALLING THE APPLIANCE

This unit is equipped with a type Y fire protection, and may be positioned
against walls that are higher than the hob.
The manufacturer cannot be held liable for damage to persons or
things caused by failure to comply with the above requirements or by
tampering with any part of the appliance.
2.1 Levelling
Adjust the four feet so as to set the appliance on a perfectly level plane.
For this purpose, loosen the lock nut and unscrew the foot. The range of
adjustment of the screw is 10 mm.
2.2 Electrical connection
Make sure the voltage and the cross-section of the power supply line
match the specifications indicated on the identification plate positioned in
the storage compartment.
Do not remove this plate for any reason.
Fit the power supply line with a multipolar cut-out device with a contact
opening gap equal to or greater than 3 mm in an easily accessible
position close to the appliance.
The appliance is fitted with
a terminal board at the rear
for electrical connections
(see following diagram). To
access, remove the rear
cover
32
Instructions for the installer