Table of Contents
Advertisement
Configuring telephone connections
Configuring telephone connections
You can configure up to six VoIP phone numbers on your phone. You need to set up a VoIP
account with a VoIP provider for each VoIP phone number. You must save the access data
for each account and for the relevant VoIP provider in the phone. You can assign a name to
every connection.
To configure the connections:
¤
Open the following Web page:
A list (see Figure 3) will be shown with all possible connections that you can configure, or
have already configured, for your phone.
Figure 3 List of possible connections
The list will show the following:
Name
Name of the connection. The name that you have defined for the connection is dis-
played (page 90) or the default name
the display if a call is received for this phone number (page 29).
Status
The status of the connection will be shown for VoIP connections:
registered
The connection is activated. The phone has been successfully registered. You can use
the connection to make calls.
Disabled
The connection is deactivated. The phone is not registering with the corresponding
account with the VoIP service. You cannot use the connection to make or receive calls.
Registration failed
The phone could not be registered with the VoIP service, e.g. because the VoIP access
data is incomplete or incorrect, or because the phone is not connected to the Internet.
There is information about this in the section "Questions and answers" from page 113
onwards.
Settings
/
Server not accessible
¢
¢
Telephony
Connections.
(IP1
to IP6). This name is shown, for example, on
(examples)
89
Advertisement
Table of Contents
