Table of Contents
Advertisement
Setting the base station phone's IP address in LAN
Automatic firmware update
Precondition: The automatic version check is activated (page 107, default setting).
Your phone will check daily whether a newer firmware update is available via the Internet
on the Siemens configuration server. If this is the case, when the handset is in idle status
the message
New firmware available!
f
Press the message key.
Press the display key to confirm the prompt.
§Yes§
~
Enter the base station system PIN (default setting: 0000).
The firmware will be loaded onto your phone.
Please note that the firmware update may take up to 3 minutes.
Please note:
– If you reply to the request with §No§, the display will not be repeated. The message
available!
will only be shown again if a newer version of the firmware than the one rejected is
available.
– You can deactivate the automatic version check via the Web configurator (page 107).
Making VoIP settings
For VoIP telephony you need to make the following settings:
u
IP settings for the telephone connection to the LAN (to the router). You can make these
settings on the handset (page 59) or (if there is already a connection to the PC) via the
phone Web configurator (page 87).
u
VoIP settings for each of your VoIP accounts (VoIP phone numbers). You can make the
settings for up to six VoIP accounts via the Web configurator.
Alternatively, you can also set and make changes to the first VoIP account (IP1, see
page 89) via the handset. You can make the settings with (page 61) or without
(page 61) connection assistants.
Setting the base station phone's IP address in LAN
The base station requires an IP address in order to be "recognised" by the LAN (the router).
The IP address can be assigned to the base station automatically (by the router) or manu-
ally.
u
If performed dynamically, the router's DHCP server automatically assigns the base
station an IP address. The base station's IP address can be changed according to router
settings.
u
If performed manually, you assign the base station a static IP address. This may be nec-
essary depending on your network configuration.
Please note:
For how to make the local network settings on the Web configurator, turn to page 87.
is displayed and the message key f flashes.
New firmware
59
Advertisement
Table of Contents
