Mercedes-Benz Vito Operating Instructions Manual page 91

Seat rail system with quick-locking mecha-
nism
1 Seat rail
On rails 1 of the seat rail system, you
can:
e
I fit rear bench seats ( page 91)
I adjust the position of rear bench seats
( e page 89)
Moving/rotating the rear bench seat
G
Risk of injury
If passengers are to sit on the rear bench
seat, do not under any circumstances adjust
it by more than 5 cm to the front or to the
rear of the basic position marked on the
seat rail. The reduced legroom could cause
injury to passengers when braking.
The rear seat bench must be securely en-
gaged in the seat rails in the fore-and-aft di-
rection, because improperly anchored seat-
ing could move out of position when brak-
ing. The seat belts would not be able to pro-
vide adequate protection for yourself and
others.
i
You can only install rear bench seats in the
face-to-face position if the vehicle floor has
four seat anchorages in the second row of
seats.
On vehicles with three seat anchorages for
each row of seats, it is not possible to lock all
the seat legs in the face-to-face position.
i
Only move the rear bench seat when no-
body is sitting on it.
Nur fuer internen Gebrauch
Moving the comfort rear bench seat
1 Backrest release catch
2 Release lever for fore-and-aft adjust-
ment
E
To move the rear bench seat: move
the head restraints fully down
e
( page 93).
E
Pull backrest release catch 1 up.
E
Fold the backrest to the table position.
e
( page 90)
E
Pull the release lever for fore-and-aft
adjustment 2 up.
E
Move the rear bench seat to the de-
sired position by the handles.
e
( page 90)
Controls
Seats
3
ee
89