Mercedes-Benz Vito Operating Instructions Manual page 90

Controls
Seats
E
Lift the easy-entry section up and out
of the anchorage.
G
Risk of injury
Before you start your journey, make sure
that the rear seat bench is engaged.
The seat is not correctly engaged if the indi-
cator tab is not properly retracted into the
3
seat leg. In this case, repeat the seat en-
gagement process.
In the event of heavy braking or a sudden
change in the direction of travel, a rear
bench seat that is improperly engaged could
be thrown about the vehicle interior and
cause severe or fatal injuries to you and
others.
E
To fit the easy-entry section: place
front seat legs 2 of the easy- entry
section on the floor anchorage.
E
Tilt the easy-entry section backwards
slightly.
Both front seat legs engage audibly.
E
Fold the easy-entry section back.
The rear seat leg of the easy-entry sec-
tion engages audibly.
E
Fold the backrest back from the table
position to the seat position.
88
If you cannot fold the backrest back to the
upright position, the easy-entry section of
the rear bench seat is not correctly en-
gaged.
E
Fold the easy-entry section forwards.
E
Fold the easy-entry section back again.
Adjusting the backrest
Comfort rear bench seat
1 Backrest release catch
E
Pull backrest release catch 1 up at
the front or on the backrest and hold it.
E
Move the backrest to the desired posi-
tion.
E Let go of release catch 1.
The backrest engages.
Nur fuer internen Gebrauch
Seat anchorage
Seat anchorages with quick-locking mech-
anism
1 Seat anchorage
You can use seat anchorages 1 to anchor
standard and comfort bench seats.