Buttons - Mercedes-Benz Vito Operating Instructions Manual

Controls
On-board computer with steering wheel buttons - version B
Setting the date
i
Vehicles with the navigation system
COMAND APS or Sound 50 APS do not have
this submenu.
Use the buttons on the steering wheel.
Press the è or · button repeat-
E
edly until the Settings
3
in the display.
Press j to go to the submenu se-
E
lection.
Press æ or ç to select the
E
Clock/Date submenu.
Press j to select the
E
Month or Year ) function.
Press æ or ç to set the values.
E
132
Lighting submenu
Setting constant headlamp mode
If you have set constant headlamp mode
and the light switch is in the M posi-
tion, the parking lamp, low beam head-
lamps, tail lamp and licence plate lamp
menu appears
light up automatically when the engine is
running.
For safety reasons, it is only possible to
change this setting when the vehicle is
stationary. In countries where constant
headlamp mode is mandatory,
the default setting.
Date Day (or
Use the buttons on the steering wheel.
Press the è or · button repeat-
E
edly until the
in the display.
Press j to go to the submenu se-
E
lection.
Press æ or ç to select the
E
lights
Press j to select the
E
tion.
The current setting is highlighted.
Nur fuer internen Gebrauch
Constant
Settings menu appears
Driv.
submenu.
Lighting func-
Press æ or ç to select
E
Constant (constant headlamp mode).
i
If you turn the light switch to C or
B, the corresponding light switches on.
Constant headlamp mode remains activated if
the light switch is turned to U.
is
For safety reasons, it is not possible to reset
the Lighting function to the factory setting
while the vehicle is in motion. You will see the
following message in the display:Setting only
possible at standstill!
Switching the locator lighting on or off
If you switch the locator lighting to
following lamps light up when it is dark
after you have unlocked the vehicle using
the key:
I the side lamps
the tail lamps
I
I the licence plate illumination
I the front foglamps
Manual or
On , the