Main Fuse Box; Fuses; Fuse Allocation - Mercedes-Benz Vito Operating Instructions Manual

E
Press the bulb to the rear.
E
Turn it anti-clockwise and remove it
from the bulb holder.
E
Press the new bulb into the bulb holder
and screw it in clockwise.
Additional turn signal lamps on the
roof
1 Securing bolts
E
Switch the lights off.
E Unscrew the three securing bolts 1
with a suitable tool, e.g. a screwdriver.
E
Remove the turn signal lens.
E
Turn it anti-clockwise and remove it
from the bulb holder.
E
Screw the new bulb into the bulb hold-
er.
E
Replace the turn signal lens and tighten
the three securing bolts 1.
Interior light
!
Have the overhead control panel interior
light changed at a qualified specialist workshop
which has the necessary specialist knowledge
and tools to carry out the work required.
Mercedes-Benz recommends that you use a
Mercedes-Benz Service Centre for this pur-
pose.
You could otherwise damage the overhead con-
trol panel.

Fuses

i
Blown fuses must be replaced with fuses of
the same rating (which can be recognised by
the colour and amperage) and which have the
amperage specified in the fuse allocation chart.
A Mercedes-Benz Service Centre will be happy
to advise you.
G
Risk of fire
Only use fuses that have been approved for
Mercedes-Benz vehicles and which have the
correct amperage for the system con-
cerned. Do not attempt to repair or bridge
faulty fuses. A circuit overload could other-
wise cause a fire. Have the cause traced
Nur fuer internen Gebrauch
Practical advice
Electrical system
and rectified at a qualified specialist work-
shop, e.g. a Mercedes-Benz Service Centre.
E
Switch off the ignition and the electri-
cal consumers before changing a fuse.

Main fuse box

The fuse box is located in the engine com-
partment on the co-driver's side.
1 Tabs
2 Cover
E
To open: switch off all electrical con-
sumers.
E
Apply the pedal-operated parking brake
or shift the selector lever to position P
on vehicles with automatic transmis-
sion.
E
Remove the key from the ignition lock.
5
ee
329