Throttle Cut - Spektrum DX6I User Manual

Rotate the roller to select 1 servo 90 degrees or CCPM 120 degrees swashplate mixing.
SWASH TYPE
1SERVO90°
After the desired swashplate type is programmed press the roller to deselect the value.
TO RETURN TO ThE MAIN SCREEN
Press and hold the roller for more than 3 seconds then release the roller and the system will return
to the main screen.
TO RETURN TO ThE SETUP lIST
Rotate the roller to highlight LIST in the upper right corner then pressing the roller will return the system to the
SETUP LIST screen.
90
Reduce photo to 13.5%
List
SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE

ThROTTlE CUT

The DX6i offers a Throttle Cut function. When the Throttle Cut button is pressed, the throttle moves to a
preprogrammed position (low throttle, low trim) allowing the safe and convenient shut down of the engine.
TO ACTIvATE ThE ThROTTlE CUT fUNCTION
Press the ROLLER and hold while turning on the transmitter. When SETUP LIST appears on screen
release the roller.
Alternatively the setup list can be accessed from the main screen by pressing the roller to access the ADJUST LIST,
then scrolling through the ADJUST LIST by rolling the roller to highlight SETUP LIST then pressing the roller.
SETUP LIST
MODEL TYPE
Rotate the roller to highlight THRO CUT then press the roller to access the Throttle Cut function.
SETUP LIST
REVERSE
THRO CUT
D/R&COMBI
THRO CUT
POSITION - INH
SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE
Reduce photo to 13.5%
Main
Reduce photo to 13.5%
Main
6
Reduce photo to 13.5%
List
91