Binding - Spektrum DX6I User Manual

bINDING

The AR6200 receiver must be bound to the transmitter before it will operate. Binding is the process of teaching the
receiver the specific code of the transmitter so it will connect to that specific transmitter. Once bound, the receiver
will only connect to the transmitter when the previously bound model memory is selected. If another model
memory is selected, the receiver will not connect. This feature is called ModelMatch
using the wrong model memory.
1. With the system hooked up as shown, insert the bind plug in the charge plug receptacle.
2. Turn on the receiver switch (not included). Note that the LEDs on both receivers should be flashing,
indicating that the receiver is ready to bind.
18
™ and prevents flying a model
SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE
3. Establish the desired fail-safe stick positions: normally low throttle and flight controls neutral.
4. Pull and hold the trainer switch on the top of the transmitter while turning on the power switch. Within
a few seconds the system should connect. The LEDs on the receivers should go solid, indicating the
system has connected.
5. Remove the bind plug from the charge jack before turning off the receiver and store it in a
convenient place.
6. After you've programmed your model, it's important to rebind the system so the true low throttle and
neutral control surface positions are programmed.
SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE 19