Spektrum DX6I User Manual page 37

Rotate the roller to select the desired master channel.
• THRO: Throttle
• AILE: Aileron
• ELEV: Elevator
• RUDD: Rudder
• GEAR: Retractable Landing Gear
• FLAP: Flap
Press the roller to deselect the master channel then rotate the roller to select the slave channel.
Press the roller to access the slave channel selection.
Rotate the roller to select the desired slave channel.
• THRO: Throttle
• AILE: Aileron
• ELEV: Elevator
• RUDD: Rudder
• GEAR: Retractable Landing Gear
• FLAP: Flap
SElECTING ThE MIXING vAlUES
Rotate the roller to highlight the desired rate and direction.
Reduce photo to 13.5%
THRO≥ THRO ACT
RATE D
SW AIL D/R TRIM ACT
Press the roller to access the rate value.
Using the roller, rotate to adjust the desired mixing values. Note that positive (+) and negative (-) values are
available and affect the direction of the slave servo travel.
After the desired value is programmed press the roller to deselect the value.
72
MIX 1
List
0% U 0%
SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE
SWITCh fUNCTIONS
The Mixes can be turned off and on using one of the following switches:
ON- Always on
GEAR- Gear switch forward
FLAP- Flap switch down
AIL D/R- Aileron Dual Rate switch up
ELE D/R- Elevator Dual Fate switch up
MIX- Mix switch forward
TO PROGRAM ThE MIX SWITCh
Rotate the roller to highlight SW.
THRO≥ THRO ACT
RATE D
SW AIL D/R TRIM INH
Press the roller to access the switch selection function.
Rotate the roller to select the desired switch.
After the desired switch is programmed press the roller to deselect the value.
SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE
Reduce photo to 13.5%
MIX 1
List
0% U 0%
73