Bicycle Valve Sclaverand Valve; Transporting The Ebike - SMART ebike Owner's Manual

The approved tyres (
directional design. An arrow : on the tyre
wall shows the direction of rotation.
Make sure that arrow : is pointing in the
direction of travel when fitting the tyres.
Bicycle valve
Sclaverand valve
:
Knurled nut (ride position)
;
Valve cap
=
The ebike rims are designed for tubes with
Sclaverand valve :. Once you have checked
the tyre pressure or inflated the tyre,
tighten knurled nut ;.
Make sure that a valve cap is always used to
protect valve =.
Flat tyre
If possible, always replace the tube
Y
( page 70) after a puncture. This ensures
the optimum trueness of your wheels.

Transporting the ebike

! When transporting the ebike, make sure
that no objects can become caught in the
Carbon Drive belt. The Carbon Drive belt
is particularly at risk when you trans-
port the ebike with other bicycles or
with the rear wheel removed.
Y
page 70) have a
Transporting the ebike
Please observe the following information
to avoid damaging your ebike during
transport
X
With the wheels removed: slide the yellow
transport locks into the brake callipers.
X
Pull on the brake lever and fasten it to
the grip using a strong elastic band or a
cable tie.
X
Once you have removed the wheels, place
or lay them down carefully to prevent the
brake discs from becoming bent or dirty.
X
After storage or transport upside down:
check the operation of the brake system
and if in doubt, have the brakes bled at a
qualified specialist workshop.
X
Remove the battery before transporting
Y
the ebike ( page 41).
X
Place the rubber cap over the electrical
contacts in the battery holder.
X
Before transporting the ebike on a vehi-
cle's rear rack or roof carrier, remove
any accessories that are not permanently
attached to the ebike, e.g. control con-
sole, smartphone and mesh pockets.
i
It is not permitted to carry the smart
ebike battery on board a passenger aero-
plane.
The weight of the ebike and the frame
design place specific demands on a vehi-
cle's rear rack or roof carrier. Unsuitable
bicycle racks may break during a journey
or may not hold the ebike securely.
Only use suitable bicycle racks for trans-
porting the ebike. Observe the information
on roof load and noseweight in the vehicle
Owner's Manual and the information in the
bicycle rack's assembly/operating
instructions.
45
Z