Removing - SMART ebike Owner's Manual

Stowing and features
32
Mounting the smartphone cradle
Removing the stem face plate
Electrical connectors on the headlamp
Control console contact plate
Data cable
:
Generator sensor cable
;
Control console contact plate
=
Screw
?
Stem face plate
A
X
Remove control console (
X
Pull sensor cable ; off contact plate
=.
X
Loosen retainer of data cable : using a
screwdriver and detach data cable :
from contact plate =.
X
Unscrew screw ? using a T20 Torx wrench
and pull contact plate = upwards
slightly. As you do so, press against con-
tact plate = from underneath around
electrical connectors : and ;.
X
X
Removing the cover
:
;
X
X
X
Mounting the smartphone cradle
Y
page 25).
:
;
X
X
X
Pull face plate A backwards.
Pull contact plate = upwards.
Screws for cover/headlamp casing
Cover
Unscrew screws : using a 2.5 mm (0.1 in)
Allen key.
Remove cover ;.
Screw in screws : for the headlamp cas-
ing again and tighten to a torque of
1 Nm (0.74 lb-ft).
Front handlebar clamp screws
Rear handlebar clamp screws
Unscrew front handlebar clamp
screws : using a 5 mm (0.2 in) Allen key.
Position the smartphone cradle on the
handlebar clamp.
Insert screws : through the smartphone
cradle and handlebar clamp.