Qualified Specialist Workshop - SMART ebike Owner's Manual

>> Introduction.
10
Drive belt and pulleys
R
Battery
R
If work on electronic equipment and its
software is carried out incorrectly, this
equipment could stop functioning. The
electronic systems are linked together by
interfaces. Modifications to electronic
systems may also cause systems that have
not been modified to malfunction. These
malfunctions could affect the operating
safety of your ebike and therefore also have
a considerable effect on your safety.You
should therefore have all work and modi-
fications to electronic components car-
ried out at a qualified specialist work-
shop.
Do not make any modifications or carry out
work, such as drilling, soldering or weld-
ing, on the frame or other load-bearing
components. The stability and the service
life of the components could be affected as
a result.
If you remove warning stickers, you or oth-
ers may not be aware of possible dangers.
Leave warning stickers in position.
Rotating components, such as wheels, drive
belt, pedal cranks or pedals, could trap and
pull in parts of the body or clothing. Make
sure that neither clothing nor objects
being carried get caught in rotating parts.
Wear close-fitting clothing. Never wear a
scarf.
After braking, in particular after a long
downhill stretch, the brake discs, brake
callipers as well as quick-release devices
and axle nuts may be very hot. Wait until
these components have cooled down before
touching them.
Do not ride without the battery or without
the control console. If the battery or the
control console are not fitted then the
lighting system will not function. Riding
without an operational lighting system is
not permitted, depending on national reg-
ulations.

Qualified specialist workshop

A qualified specialist workshop has the
necessary special skills, tools and quali-
fications to correctly carry out any neces-
sary work on your ebike. This particularly
applies to work relevant to safety.
Always have the following work on your
ebike carried out at a qualified specialist
workshop:
work relevant to safety
R
service and maintenance work
R
repair work
R
modifications, installations and con-
R
versions
work on electronic components
R
work on the drive system
R
smart recommends that you use a smart
dealer which is qualified to carry out work
on smart ebikes.
Correct use
Observe the following information when
using the ebike:
the safety notes in the printed Owner's
R
Manual and in the electronic Owner's
Manual on CD
the technical data in the printed Owner's
R
Manual and in the electronic Owner's
Manual on CD
traffic rules and regulations
R
laws and safety standards applicable to
R
vehicles
The configuration of your smart ebike can
vary, depending on the country in which you
purchased it. Using the ebike in other
countries could therefore contravene local
laws. If necessary, have the configuration
of the ebike adjusted for the respective
country.